Slime dryer running particularity slime itself has high humidity, high adhesion, during drying wet slurry via conveyor into the slime broken equipment, after massive slime fast beaten After entering the negative pressure of the dryer divided into the following four workspaces: one is to guide the feed zone, wet slime enter this area after being in contact with the high temperature vacuum hot air quickly evaporate a lot of water, slime dryer at large lead angle of the copy board copy move down, do not form a bond will be introduced next workspace; Second, is to clean up areas, dryer wet slime in this area is expected to form a copy board took a curtain state, when the material is easy to fall cylinder wall form a bond phenomenon in this region due to equipment design cleaning device, cleaning device can quickly clean out the cylinder wall adhesive slime, in the process, the cleaning device for the material caking group also played ball crushing effect, thereby increase the heat exchange area, improve the efficiency of heat and mass transfer and improve the drying rate; three, is inclined lifting plate area, this area is a cool, dry area, slime in this area has shown a low moisture loose state, Dryer This zone has the phenomenon does not have adhesive, after the water after the heat exchange requirements of the finished product to achieve the desired movement into the final discharge zone; four, is the discharge zone, the host dryer drum in this region does not copy board, the material In this area the rolling glide to the discharge port, complete the drying process. Www.gycxjc.com slime slime dryer drying equipment www.cxhongganji.com